|
Clipping is a form of waveform distortion that occurs when an amplifier is overdriven and attempts to deliver an output voltage or current beyond its maximum capability. Driving an amplifier into clipping may cause it to output power in excess of its published ratings. == Overview of clipping == When an amplifier is pushed to create a signal with more power than its power supply can produce, it will amplify the signal only up to its maximum capacity, at which point the signal can be amplified no further. As the signal simply "cuts" or "clips" at the maximum capacity of the amplifier, the signal is said to be "clipping". The extra signal which is beyond the capability of the amplifier is simply cut off, resulting in a sine wave becoming a distorted square-wave-type waveform. Many electric guitar players intentionally overdrive their guitar amplifiers to cause clipping in order to get a desired sound (see guitar distortion). Amplifiers have voltage, current and thermal limits. Clipping may occur due to limitations in the power supply or the output stage. Some amplifiers are able to deliver peak power without clipping for short durations before energy stored in the power supply is depleted or the amplifier begins to overheat. Amplifier power ratings are typically established by driving the device-under-test to the onset of clipping, to a predetermined distortion level, variable per manufacturer or per product line. Driving an amplifier to 1% distortion levels will yield a higher rating than driving it to 0.01% distortion levels.〔Quilter, Patrick (2004). ("How to Compare Amplifier Power Ratings." ) ''Sound and Song''. Retrieved on March 18, 2010.〕 Similarly, testing an amplifier at a single mid-range frequency, or testing just one of two channels, will yield a higher rating than if it is tested throughout its intended frequency range with both channels working. Manufacturers may use these methods to market amplifiers whose published maximum power output includes some amount of clipping in order to show higher numbers.〔 For instance, the Federal Trade Commission (FTC) established an amplifier rating system in which the device is tested with both channels driven throughout its advertised frequency range, at no more than its published distortion level. The Electronic Industries Association (EIA) rating system, however, determines amplifier power by measuring a single channel at 1,000 Hz, with a 1% distortion level—1% clipping. Using the EIA method rates an amplifier 10 to 20% higher than the FTC method, at the cost of audio fidelity.〔 抄文引用元・出典: フリー百科事典『 ウィキペディア(Wikipedia)』 ■ウィキペディアで「Clipping (audio)」の詳細全文を読む スポンサード リンク
|